HALF-BRIDGE LOAD CELL WEIGHT SENSOR 50KG

LOAD CELL
Half-Bridge Load Cell Weight Sensor 50kg

Think it... Make it... Invent!
SKU: PROD0236


DESCRIPTION

This weight sensor (load cell half bridge 50KG) is suitable for electronic balance and other high accuracy electronic weighing devices.

When measuring, the correct force is applied to the outer side of the strain E-shaped beam portion of the sensor (i.e., a strain gauge affixed to the middle, with a beam of white plastic cover arm) and the outside edges to form a shear force in the opposite direction, (i.e., in the middle of strain beam bending necessary changes can occur under stress, strain beam side by another force can not have a barrier.)

The sensor use the following three methods:

1, using a sensor with external resistors full bridge measurement range of a sensor range: 50kg. Higher requirements for external resistor

2, the use of only two full-bridge sensors measuring range is the range of the two sensors and: 50kgx2 = 100kg

3, the use of four full-bridge sensors measuring range is the range of four sensors and: 50kgx4 = 200kg

PACKAGE INCLUDES:

1 x Load Cell 50kg Weight Sensor

TECHNICAL DETAILS

Wiring
Red Signal
Blue Vcc
Black GND

Rated Load 50kg
Rated Output 1.0 ±0.1mV/V
Nonlinearity 0.08 %FS
Hysteresis 0.1 %FS
Repeatability 0.05 %FS
Temperature Effect on Output 0.02 %FS/C
Temperature Effect on Zero 0.02 %FS/C
Zero Balance ±0.1000 mV/V
Operating Temperature Range -20 ~ 65 C
Recommended Supply Voltage 5Vdc
Maximum Supply Voltage 8Vdc
Input Resistance 1000±20?
Output Resistance 1000±20?
Insulation Resistance ?5000M?
Level of Protection IP65
Material Aluminum Alloy
Cable ?0.8×460 mm

Contact us:
T (+63) 02 577 8214
M (GLOBE) (+63) 995 629 48 43
M (SMART) (+63) 949 966 59 73
Email: [email protected]
Facebook: EDW ElecDesignWorks
Website: www.elecdesignworks.com
Address: 2nd flr. CW Arcade Bldg., #20 Alcalde Jose St. Brgy Kapasigan Pasig City, Philippines 1600