OBSTACLE AVOIDANCE SENSOR

Think it... Make it... Invent!
SKU: PROD0218


Obstacle Avoidance Sensor

Description:

When the module detects an obstacle in front of the signal , the green indicator light on the board level , while low-level continuous output signal OUT port , the module detects the distance 2 ~ 30cm, detection angle 35 °, the distance can detect potential is adjusted clockwise adjustment potentiometer to detect the distance increases ; counterclockwise to adjust the potentiometer to reduce the detection distance. Active infrared sensors to detect the reflected , and thus the shape of the reflectivity of the target detection range is critical. The minimum detection distance which black , white maximum ; small objects from a small area , a large area from the Grand. The output port OUT sensor module can be directly connected to the microcontroller IO port , you can directly drive a 5V relay Connection : VCC-VCC; GND-GND; OUT-IO

Specification

- Connection : VCC-VCC; GND-GND; OUT-IO
- Using the comparator LM393, stable
- Can be used for 3-5V DC power supply modules . When the power is turned on, the red power indicator light
- With the screw holes of 3mm , easy fixed installation
- Board Size : 3.1CM * 1.5CM / 1.22 * 0.59?
- Each module shipments comparing the threshold voltage has been adjusted by the potentiometer is good , not exceptional circumstances, do not arbitrarily adjust the potentiometer
Interface Description (3-wire):
1. VCC: External 3.3V-5V voltage (can be directly connected to 5v MCU and 3.3v MCU)
2. GND: GND External
3. OUT: Small board digital output interfaces (0 and 1


Contact us:
T (+63) 02 577 8214
M (GLOBE) (+63) 995 629 48 43
M (SMART) (+63) 949 966 59 73
Email: [email protected]
Facebook: EDW ElecDesignWorks
Website: www.elecdesignworks.com
Address: 2nd flr. CW Arcade Bldg., #20 Alcalde Jose St. Brgy Kapasigan Pasig City, Philippines 1600