We are one of the largest free online selling communities with thousands of active sellers.
249808620 views
Do you have something to sell? Your next sale might be just a few clicks away.
4.7 stars
Based from 899 member feedbacks. We value your suggestions and use it.
Copyright 2021 MYBENTA. All Rights Reserved. Use of this Web site constitutes acceptance of the terms of service and privacy policy. Designated trademarks and brands are the property of their respective owners.
100% Filipino-owned. Free Forever.
Think it... Make it... Invent!
SKU: PROD0237
The LM386 is a power amplifier designed for use in low voltage consumer applications.
The LM386 is a power amplifier designed for use in low voltage consumer applications. The gain is internally set to 20 to keep external part count low, but the addition of an external resistor and capacitor between pins 1 and 8 will increase the gain to any value from 20 to 200. The inputs are ground referenced while the output automatically biases to one-half the supply voltage. The quiescent power drain is only 24 milliwatts when operating from a 6 volt supply, making the LM386 ideal for battery operation.
TECHNICAL DETAILS
Product Category Audio Amplifiers
Class Class AB
Output Power 1W
Package / Case PDIP-8
Supply Voltage 12 V
Supply Voltage 4 V
Maximum Operating Temperature 70C
Minimum Operating Temperature 0C
Number of Channels 1 Channel
Operating Supply Current 4mA
Power Dissipation 1.25W
PIN CONFIGURATION
Terminals 1 and 8 represent the gain control of the amplifier. These are the terminals where you can adjust the gain by placing a resistor and capacitor or just capacitor between these terminals. In this circuit, we will place a 10µF capacitor between these terminals for the highest voltage gain.
Terminals 2 and 3 are the sound input signal terminals. These are the terminals where you place the sound which you want to amplify. Terminal 2 is the -input and Terminal 3 is the +input. In our circuit, the positive sound signal will be placed on terminal 3 and terminal 2 will be tied to ground.
Terminal 4 is GND (ground) and will be tied to ground in the circuit.
Terminal 5 is the output of the amplifier. This is the terminal in which the amplified sound signal comes out.
Terminal 6 is the terminal which receives the positive DC voltage so that the op amp can receive the power it needs to amplify signals.
Terminal 7 is the Bypass terminal. This can bypass 15K? resistors. This pin is usually left open or is wired to ground. However, for better stability, a capacitor is added in our circuit because this can prevent oscillations in the op amp chip.
Contact us:
T (+63) 02 577 8214
M (GLOBE) (+63) 995 629 48 43
M (SMART) (+63) 949 966 59 73
Email: [email protected]
Facebook: EDW ElecDesignWorks
Website: www.elecdesignworks.com
Address: 2nd flr. CW Arcade Bldg., #20 Alcalde Jose St. Brgy Kapasigan Pasig City, Philippines 1600
This seller has been a member since: May. 28, 2015
Member Location:
Total Classifieds: 650
Why seller feedback is important?
Transact with most credible & reputable sellers
Know the seller you are going to deal with
Claim warranty long after purchasing the item
Warn you and other buyers against scams
Motivates sellers to provide good service