STEPPER MOTOR DRIVER DRV8825

FOR CEBU MEET-UPS ONLY.
Discount if with FEEDBACK.

Condition: New

Description:
---> The module has an interface pinout is almost the same with A4988 stepper motor drive carrier, so that it can be used as a higher performance in a pull-down menu the plates replaced in many applications.
---> DRV8825 features an adjustable current limit, overcurrent and overtemperature protection, six micro-resolution (down 1/32-step).
---> It uses 8.2 - 45V, can provide up to about 1.5 per phase no heat sink or forced air flow (rated up to 2.2 per volume sufficient additional cooling).

Feature:

---> Simple step and direction control interface
---> The interface can connect directly with 3.3V and 5V systems
---> Support over-temperature thermal shutdown, over-current shutdown and under-voltage lockout
---> Support short-to-ground and shorted-load protection
---> Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
---> 4-layer, 2 oz copper PCB for improved heat dissipation
---> Adjustable current control support you to set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
---> Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
---> 45V maximum supply voltage
---> Built-in regulator (needed external logic voltage supply)