FORM OIL

Look for: Rica Encinarial
Tel No: 423 8315
Cell No: 0923 477 3271
Email: [email protected]

Form Oil is concentrated mould oil suitable for use with wooden as well as steel moulds as release agent for concrete and brick. The basic function of Form Oil is to prevent the adhesion of wet brick or concrete to the mould and thus facilitate the removal of the brick or concrete from its mould. As the brick or the concrete is easily removed, thus its surface will be maintained. Form Oil will not affect the curing of the brick or concrete and thus will not affect its strength.
Form Oil is concentrated mould oil, it can be diluted with 10 parts up to 20 parts maximum of water during use. The method of preparing the emulsion of Form Oil in site is as follow:
1.) Weigh the required amount of Form Oil into the blending tank.
2.) While agitating, add in the water slowly.
3.) Normally 1 parts of Form Oil can be diluted with 10 parts of water.
4.) If proper prepared, the emulsion should be stable for at least 3 - 5 days. But if any separation occurred, it can be easily re-mixed by agitation.
The advantages of Form Oil over the traditional oil based mould release agents are:
• It is more economical.
• It can be easily cleaned.
• The working place will be mire tidy and clean.


Content: 20 liters