We are one of the largest free online selling communities with thousands of active sellers.
250198332 views
Do you have something to sell? Your next sale might be just a few clicks away.
4.7 stars
Based from 899 member feedbacks. We value your suggestions and use it.
Copyright 2021 MYBENTA. All Rights Reserved. Use of this Web site constitutes acceptance of the terms of service and privacy policy. Designated trademarks and brands are the property of their respective owners.
100% Filipino-owned. Free Forever.
Arduino I/O expansion shield.
This flexible 8x8 RGB full-color LED matrix module is based on WS2812 or SK6812 intelligent control LEDs. Each LED can be independently addressed with RGB pixels that can achieve 256 levels of brightness. That’s 16777216 colors in total with a scanning frequency no less than 400Hz!
The LED panel is single wire control board. We have customized a special cable to make it compatible with Arduino I/O expansion shields without any soldering. The module also supports cascading control. All you need to do is connect Din to the DOUT port. In combination with the open source Arduino library, you can control an entire array of LEDs using just one pin!
Note:
Each LED requires a maximum current of 18mA. When multiple modules are in use, it is recommended to use the DFRobot Gravity IO expansion board to power multiple LEDs matrix via the Servo Power Port.
SPECIFICATION
- Operating Voltage: 5V
- LED Type: SK6812/WS2812
- Communication Interface: Gravity 3Pin interface
- Operating Temperature: -25 ~ +80 ?
- Dimension: 80*80 mm/ 3.15*3.15 inches
- Weight: 130g
This seller has been a member since: Feb. 11, 2017
Member Location:
Total Classifieds: 1345
Why seller feedback is important?
Transact with most credible & reputable sellers
Know the seller you are going to deal with
Claim warranty long after purchasing the item
Warn you and other buyers against scams
Motivates sellers to provide good service